1,291
edits
→After you print
No edit summary |
|||
| Line 35: | Line 35: | ||
* Redrill holes | * Redrill holes | ||
Removing the raft shouldn't be too hard, use a sharp knife for this task. The extruder leaves some excess filament when it does hard turns or stops for a moment. The excess material creates visible seams on your object. The best way to remove them is to use a knife and cut off anything that's big and comes off easily. Anything else must be sanded. Use sandpaper or the band sander from the workshop. Holes in your object will not have the same exact diameter as in your 3d model. Use the stand drill to redrill any holes that must have a specific diameter. When using a drill on plastic never use high rpm or the plastic will melt and destroy you drill bit. | Removing the raft shouldn't be too hard, use a sharp knife for this task. The extruder leaves some excess filament when it does hard turns or stops for a moment. The excess material creates visible seams on your object. The best way to remove them is to use a knife and cut off anything that's big and comes off easily. Anything else must be sanded. Use sandpaper or the band sander from the workshop. Holes in your object will not have the same exact diameter as in your 3d model. Use the stand drill to redrill any holes that must have a specific diameter. When using a drill on plastic never use high rpm or else the plastic will melt and destroy you drill bit. | ||
==Links== | ==Links== | ||