(→Design) |
|||
| Line 13: | Line 13: | ||
This is the circuit board of the webcam. Three of the wires on the back side of the board became detached so I soldered them back onto the board. I have kept the button for capturing still images on the webcam for now, but may remove it later. | This is the circuit board of the webcam. Three of the wires on the back side of the board became detached so I soldered them back onto the board. I have kept the button for capturing still images on the webcam for now, but may remove it later. | ||
== Failed Idea == | |||
[[File:Attempt1.jpg|250px]] | |||
My first idea was to also create the plastic housing for my microscope out of a plastic container. However, this failed because the plastic was too brittle and would crack when I attempted to cut it. Using a thicker plastic container also failed as the plastic proved too hard to cut with a craft knife, and splintered, causing injury to my fingers while I was attempting it. Perspex is much less brittle and will be a much better material with which to house my microscope. | |||
== Design == | == Design == | ||
Revision as of 23:16, 25 November 2012
Deconstruction
The outer components of the webcam. I have removed the lens but will reattach it later. The plastic casing proved somewhat hard to remove. The plastic is tough and had to be removed with the help of pliers.
This is the circuit board of the webcam. Three of the wires on the back side of the board became detached so I soldered them back onto the board. I have kept the button for capturing still images on the webcam for now, but may remove it later.
Failed Idea
My first idea was to also create the plastic housing for my microscope out of a plastic container. However, this failed because the plastic was too brittle and would crack when I attempted to cut it. Using a thicker plastic container also failed as the plastic proved too hard to cut with a craft knife, and splintered, causing injury to my fingers while I was attempting it. Perspex is much less brittle and will be a much better material with which to house my microscope.
Design
I have decided to keep my microscope design fairly simple as I have no experience in creating such an object. My design will be made of perspex cut with the use of the laser cutter, but I will also create a .stl file for the 3D printer.
This is the pdf version of the design for the laser cutter.