GMU:Sustainable Aesthetics/Passion Asasu: Difference between revisions

From Medien Wiki

Retrieved from "https://www.uni-weimar.de/kunst-und-gestaltung/wiki/GMU:Sustainable_Aesthetics/Passion_Asasu"

@@ Line 21: / Line 21: @@
 '''Code'''
+'''''arduino code :'''''
+  int pump_in =
+; // connect pump through mosfet on arduino pin 3 == PWM (fake anolog pin)
+int pump_out =
+; // connect pump through mosfet on arduino pin 5 == PWM (fake anolog pin)
+void
+setup() {
+// put your setup code here, to run once:
+pinMode(pump_in, OUTPUT); // declare pin as output pin
+pinMode(pump_out, OUTPUT); // declare pin as output pin
+Serial.begin(9800);
+}
+void
+loop() {
+// put your main code here, to run repeatedly:
+analogWrite(pump_out,
+); // turn off the pump
+// make a for loop in order top blow up the balloon while ramping the motor
+for (int i =
+; i <
+; i++) {
+analogWrite(pump_in, i); // turn on the pump_in pin with value "i"
+delay(50); // wait for 50 milliseconds
+//Serial.println(i); // print the value of i
+}
+analogWrite(pump_in,
+); // turn off the pump
+// delay: wait for some time
+delay(1000); // wait for one second
+// enter an eternal loop for prototyping
+// here will be a for loop for sucking out the air again
+// while (1) {}
+analogWrite(pump_in,
+); // turn off the pump
+// make a for loop in order top blow up the balloon while ramping the motor
+for (int i =
+; i >
+; i--) {
+analogWrite(pump_out, i); // turn on the pump_in pin with value "i"
+delay(50); // wait for 50 milliseconds
+//Serial.println(i); // print the value of i
+}
+analogWrite(pump_out,
+); // turn off the pump
+// delay: wait for some time
+delay(1000); // wait for one second
+}
 '''Materials'''