GMU:Sensor Hacklab/Aline Martinez: Difference between revisions

Line 41:

[[File:Tests3.jpg|300px]]

Until this point I was trying to figure out which value of resistances were the best to deliver a bigger range of values in the serial monitor, therefore I took notes. Kati in a consultation taught that if one measure in the multimeter the highest and lowest voltage, add those values and dived by two, one will be able to have the average voltage and use this average voltage value as a resistor and therefore, have the best performance possible from the sensor.

Revision as of 12:39, 11 June 2016 (view source) AlineMa (talk \| contribs) No edit summary ← Older edit		Revision as of 12:56, 11 June 2016 (view source) AlineMa (talk \| contribs) No edit summary Newer edit →
Line 41:		Line 41:

	[[File:Tests3.jpg\|300px]]		[[File:Tests3.jpg\|300px]]


			Until this point I was trying to figure out which value of resistances were the best to deliver a bigger range of values in the serial monitor, therefore I took notes. Kati in a consultation taught that if one measure in the multimeter the highest and lowest voltage, add those values and dived by two, one will be able to have the average voltage and use this average voltage value as a resistor and therefore, have the best performance possible from the sensor.