GMU:Sustainable Aesthetics/Passion Asasu: Difference between revisions

From Medien Wiki

Retrieved from "https://www.uni-weimar.de/kunst-und-gestaltung/wiki/GMU:Sustainable_Aesthetics/Passion_Asasu"

@@ Line 28: / Line 28: @@
    setup() {
    // put your setup code here, to run once:
+  pinMode(pump_in, OUTPUT); // declare pin as output pin
+  pinMode(pump_out, OUTPUT); // declare pin as output pin
+  Serial.begin(9800);
+  }
+  void
+  loop() {
-pinMode(pump_in, OUTPUT); // declare pin as output pin
+  // put your main code here, to run repeatedly:
+  analogWrite(pump_out,
+); // turn off the pump
-pinMode(pump_out, OUTPUT); // declare pin as output pin
+  // make a for loop in order top blow up the balloon while ramping the motor
-Serial.begin(9800);
+  for (int i =
+; i <
+; i++) {
+  analogWrite(pump_in, i); // turn on the pump_in pin with value "i"
+  delay(50); // wait for 50 milliseconds
+  //Serial.println(i); // print the value of i
+  }
+  analogWrite(pump_in,
+); // turn off the pump
+  // delay: wait for some time
+  delay(1000); // wait for one second
+  // enter an eternal loop for prototyping
+  // here will be a for loop for sucking out the air again
+  // while (1) {}
+  analogWrite(pump_in,
+); // turn off the pump
+  // make a for loop in order top blow up the balloon while ramping the motor
+  for (int i =
+; i >
+; i--) {
+  analogWrite(pump_out, i); // turn on the pump_in pin with value "i"
+  delay(50); // wait for 50 milliseconds
+  //Serial.println(i); // print the value of i
+  }
+  analogWrite(pump_out,
+); // turn off the pump
+  // delay: wait for some time
+  delay(1000); // wait for one second
+  }
-}
 '''Materials'''