Instroduction
In the Digital Lab you could find two kind of sound playing system: 『Stereo Sound System』and 『Multi-Channels Sound System』. In this case, I will introduce how to set up and playing your sound with Stereo sound system and some about trouble-shooting.
Circumstance Setting
There are totally four workstations in Digital Lab, and the right most one is used for dealing with sound playback. Location is shown below:
Equipments you will use
- RME Fireface UFX & Fireface 800 Audio Interface (Fireface UFX is a Audio Interface which support max. 30 signal inputs-outputs and 4Mics/Instrument and built-in preamps. To see more detail please visit the technical page.(RME Fireface UCX).
- Power supplier for multiple speakers.
- Sound workstation(The most right Mac Pro).
- Last but the most important! Your sound player.
Let's play the Sound
Step 1- Connect the 3.5 phone jack wire to your sound player
Step 2- Turn on 『Power supplier for multiple speakers』
The power supplier is located behind the right sight of video wall.
Step 3- Turn on 『RME Fireface UFX, FireFace 800 Audio Interface and the right side MacPro 』.
p.s.Make sure following the ordering of first turn on power supplier then audio interface, but turn off audio interface at first then power supplier. If you break this rule, the electrical peak will harm the audio system. We believe that this definitely is a bad news for all users.
Step 4- Setting up on RME Fireface UFX (For those who only want to play stereo sound, they don’t need to download the drivers and control panel. In the other word, you will need to install them if you want play multiple sound tracks.)
- Download link:Fireface 800
Example of control panel: TotalMix(For signal manage and post-mix)
- There are there main playback modes:
- Phone output(extra monitor using)
- Main output(What we use!)
- ADAT output(Only for digital Optical system)
- You could press the knob（1) which is aside of power swith to change the between the above three modes, and turn voloume knob to adjust the volume you wish.
Done!! Enjoy the Sound
Trouble shooting
Situation 1: You've already plug in sound cable but not sound?
Answer:
- Check if you have turned both power supplier for speaker system and sound workstation(Mac pro)on.
- Check if you have already turned on the Fireface UFX and Fireface 800.
Situation 2: All are truned on but still no sound?
- Check the Mac Pro and go to RME setting application(within the deck)to see if the sound card is selected to "Fireface 800" correctly.
- Open up the totalmix control panel, sending sound signal from your playback device, then check it there has signal in the stereo channal(Default is 1/2).
- Check if you have already chose the "Master out" as output mode correctly, and of course, volume up until you could listen somthing.