IFD:Interaktive Elektronik 2012/Arduino programming beginners

Using an LED on pin 13

Use an LED on pin 3

Use a Potentiometer and LED

We covered in the first lesson:

• Arduino file format (pde and ino)
• Functions of the buttons of the Arduino IDE
• Opening the Serial monitor.
• Going through the blink example.
  • setup:
    • set pin 13 to output
  • loop:
    • set pin 13 to be turned on
    • wait one second
    • set pin 13 to be turned off
    • wait one second
    • repeat the loop.

Today:

• introduce the concept of variables.
• introduce the "if" condition.
• introduce functions.

Introducing variables. int (means an integer number: 0 1 2 3 4 5 6 ... and also negative numbers. limits: -32,768 to 32,767 there are other kinds of variables. we only use int for simplicity in this lesson. valid names for variables: otto, lemonade24 and pudding not allowed names for variables: ööö äää 1234Otto (must start with an alphanumeric character) better names for variables: delayTimeOff, pinNumber, delayTimeOn

using variables

variables are a place to store numbers in the memory of a computer. They make life for us now: replace pin number by a variable - changing the pin is much less tedious and cumbersome. replacing the delay by a variable - only change it once.

Changing variables during runtime (while the program is running) is also possible:

Most simple example of changing a variable:

myVariable = 100;
delay(myVariable);
myVariable = 1000;
delay(myVariable);

Having some random fun

delayTime = random(1000);

will assign a random number from 1 to 1000.

Some other useful ways to assign a new value to a variable: today we use: + - * increasing the delay time:

delaytime = 100;
delaytime = delaytime + 100;

in the first line delaytime gets the new value 100 in the second line something apparently strange happens - how is this possible? This line is not meaning a mathematical equality. The right side of the equals sign (=) is calculated first and then assigned to the left side of the equals sign. The following 3 steps happen - invisible for you inside the program when it's running:

Step 1: The old delaytime is replaced by 100

 delaytime = 100 + 100

Step 2: The values on the right side of the equals sign are added and assigned to the variable:

 delaytime = 200

Now the value of delaytime is 200.

a new kind of output: analogWrite

Since we are working with LEDs a desirable feature would be to set the brightness. analogWrite lets us do this:

 analogWrite(pinNumber,Brightness);

or more generally since it is not only meant for brightness:

 analogWrite(pinNumber,analogValue);