234
edits
→THE PROJECT
No edit summary |
|||
| Line 21: | Line 21: | ||
In the video below, you can find a detailed explanation on the patch, and how you setup the data inputs | In the video below, you can find a detailed explanation on the patch, and how you setup the data inputs | ||
{{#ev:youtube|youtu.be/5jJLMSbgWjs}} | {{#ev:youtube|youtu.be/5jJLMSbgWjs}} | ||
To setup the piezo sensors, you need to connect them to your Max apllication using an Arduino and USB serial. You'll need the following | |||
- 1 Arduino Uno (or Mega etc.) including USB connection | |||
- 5 piezo sensors | |||
- 5 resistors each ~100 ohms | |||
- 10 jumper wires (male) | |||
- some tape to attach the piezos to a surface like your desk | |||
You will have to connect them like this: (made with tinkercad.com) | |||
[[File:Circuit2.jpg|400px]] | |||
The positive wire of the piezo has to be put to the A0-4 inputs, the negative wire to the ground. | |||
It should look like this in the end | |||
== Weekly Tasks: == | == Weekly Tasks: == | ||