GMU:PCB Arts/Ulrike Katzschmann: Difference between revisions

GMU:PCB Arts/Ulrike Katzschmann (view source)

1 byte added , 21 March 2021

m

382

edits

Revision as of 17:10, 21 March 2021 (view source) Ulrike (talk \| contribs) m (→‎Semesterproject) ← Older edit		Revision as of 17:10, 21 March 2021 (view source) Ulrike (talk \| contribs) m (→‎Semesterproject) Newer edit →
Line 36:		Line 36:

	The third part is much simpler than the second on. It only consists of four LEDs and four resistors. Above each LED a resistor is connected to it. The resistors regulate the voltage that flow into the LEDs. if these LEDs are submited to to much current they will burn out.		The third part is much simpler than the second on. It only consists of four LEDs and four resistors. Above each LED a resistor is connected to it. The resistors regulate the voltage that flow into the LEDs. if these LEDs are submited to to much current they will burn out.


	Here is the link to the website that I used as research. It explains the "Astable Multivibrator Curcuit", from this schematic I build up my curcuit.		Here is the link to the website that I used as research. It explains the "Astable Multivibrator Curcuit", from this schematic I build up my curcuit.