1,291
edits
no edit summary
No edit summary |
No edit summary |
||
| Line 8: | Line 8: | ||
===Choose your filament=== | ===Choose your filament=== | ||
<br clear="all" /> | |||
[[File:RapMan_HowTo-filaments.jpg|right|thumb|Different filaments (ABS and PLA)]] | [[File:RapMan_HowTo-filaments.jpg|right|thumb|Different filaments (ABS and PLA)]] | ||
Chosing the right filament to print with is usually the first step when printing an object. The different plastics have different properties that might influence your print and each plastic has its own export settings. There is a good overview of commonly used materials over at the [http://www.bitsfrombytes.com/wiki/index.php?title=Category:Filament BfB Wiki]. | Chosing the right filament to print with is usually the first step when printing an object. The different plastics have different properties that might influence your print and each plastic has its own export settings. There is a good overview of commonly used materials over at the [http://www.bitsfrombytes.com/wiki/index.php?title=Category:Filament BfB Wiki]. | ||
===Preparing your data=== | ===Preparing your data=== | ||
<br clear="all" /> | |||
[[File:RapMan_HowTo-stl-meshlab.jpg|right|thumb|Stl file in Meshlab]] | [[File:RapMan_HowTo-stl-meshlab.jpg|right|thumb|Stl file in Meshlab]] | ||
Preparing your data for printing is divided into two steps. | Preparing your data for printing is divided into two steps. | ||
| Line 21: | Line 23: | ||
===Checking for loose parts=== | ===Checking for loose parts=== | ||
<br clear="all" /> | |||
[[File:RapMan_HowTo-loose-screw-locations.jpg|right|thumb|Some locations where screws might loosen]] | [[File:RapMan_HowTo-loose-screw-locations.jpg|right|thumb|Some locations where screws might loosen]] | ||
During the printing process parts might become loose. Mostly these are the screws on anything that is moving. Some places you should check are the screws of the x- and y-stepper motor pulleys and the screws of the extruder gears. Also check if the belts are tight enough. Loose parts will make your print look ugly. | During the printing process parts might become loose. Mostly these are the screws on anything that is moving. Some places you should check are the screws of the x- and y-stepper motor pulleys and the screws of the extruder gears. Also check if the belts are tight enough. Loose parts will make your print look ugly. | ||
==Printing== | ==Printing== | ||
<br clear="all" /> | |||
[[File:RapMan_HowTo-rapman-printing.jpg|right|thumb|Some locations where screws might loosen]] | |||
Printing is fairly easy. Copy the G-code file to the sd card, put it into the RapMan controller and power it on. Then select you file and run it. | Printing is fairly easy. Copy the G-code file to the sd card, put it into the RapMan controller and power it on. Then select you file and run it. | ||
==After you print== | ==After you print== | ||
<br clear="all" /> | |||
[[File:RapMan_HowTo-printed-object.jpg|right|thumb|The printed object]] | [[File:RapMan_HowTo-printed-object.jpg|right|thumb|The printed object]] | ||
After your object is printed there are some steps you might want to do: | After your object is printed there are some steps you might want to do: | ||